Home › Printers › Flashforge Adventurer 5M

Flashforge Adventurer 5M filament settings guide

The Flashforge Adventurer 5M has a direct-drive extruder with an all-metal hotend. Below are tuned starting profiles for every common filament on the Flashforge Adventurer 5M.

⚡ Quick answer: The Flashforge Adventurer 5M handles PLA, PETG and TPU easily, and its all-metal hotend opens up higher-temp materials.

Filament profiles for the Flashforge Adventurer 5M

Material	Hotend	Bed	Speed	Fit
PLA	205°C	60°C	150 mm/s	✅
PLA+	215°C	60°C	143 mm/s	✅
Silk PLA	215°C	60°C	128 mm/s	✅
Matte PLA	210°C	60°C	143 mm/s	✅
Wood PLA	210°C	60°C	120 mm/s	✅
Tough PLA	220°C	60°C	135 mm/s	✅
PVB	215°C	70°C	128 mm/s	✅
PETG	240°C	80°C	113 mm/s	✅
PETG-CF	250°C	80°C	113 mm/s	✅
PETG HF	245°C	80°C	158 mm/s	✅
ABS	245°C	100°C	105 mm/s	⚠️
ASA	250°C	100°C	105 mm/s	⚠️
Nylon (PA)	260°C	90°C	98 mm/s	⚠️
Nylon CF	265°C	90°C	98 mm/s	⚠️
PLA-CF	220°C	60°C	135 mm/s	✅
Polycarbonate	280°C	110°C	83 mm/s	⚠️
TPU	225°C	45°C	53 mm/s	✅
TPU 85A	230°C	45°C	38 mm/s	✅
HIPS	240°C	100°C	105 mm/s	⚠️
PVA	200°C	60°C	90 mm/s	✅

Sources & how we tuned this

These settings are community-tested starting points, cross-checked against manufacturer guidance and trusted material references:

Last verified: 2026-07-17. Always run a temperature tower and a small calibration print for your exact spool.