Home › Bambu Lab X1 Carbon › TPU
TPU settings for the Bambu Lab X1 Carbon
Great match
These are tuned starting settings for printing TPU on the Bambu Lab X1 Carbon. The Bambu Lab X1 Carbon has a direct-drive extruder and an all-metal hotend in an enclosed chamber, so we set the hotend to 225°C and the bed to 50°C. TPU is flexible and prints best slow with a direct-drive extruder; Bowden setups must go very slow.
225°C
Hotend
50°C
Bed
25 mm/s
Speed
60%
Part fan
Recommended TPU profile
| Hotend temperature | 225°C (tower 210–235°C) |
| Bed temperature | 50°C |
| Print speed | 25 mm/s |
| Retraction | 1 mm (direct drive) |
| Part cooling fan | 60% |
| Bed adhesion | Sticks well; print slow and disable extra retraction. |
| Nozzle | Brass 0.4 mm is fine |
| Difficulty | Intermediate |
💡 Best uses for TPU: phone cases, gaskets, wheels.
FAQ
- What temperature should I print TPU on the Bambu Lab X1 Carbon?
- Start at 225°C for the hotend and 50°C for the bed, then run a temperature tower across 210–235°C to dial in your exact filament brand.
- What print speed works for TPU on this printer?
- Around 25 mm/s is a safe starting point on the Bambu Lab X1 Carbon. This printer can go faster once the profile is tuned, but start conservative for clean walls.
- What retraction should I use?
- Use about 1 mm of retraction (direct drive needs very little). If you see stringing with TPU, raise retraction speed before distance and dry the filament.
- Do I need an enclosure for TPU on the Bambu Lab X1 Carbon?
- No, TPU prints fine in the open on the Bambu Lab X1 Carbon.