Home › Elegoo Neptune 4 › Silk PLA
Silk PLA settings for the Elegoo Neptune 4
Great match
These are tuned starting settings for printing Silk PLA on the Elegoo Neptune 4. The Elegoo Neptune 4 has a direct-drive extruder and an all-metal hotend, so we set the hotend to 215°C and the bed to 55°C. Silk PLA prints best slow and slightly hot to keep its glossy metallic sheen.
215°C
Hotend
55°C
Bed
56 mm/s
Speed
100%
Part fan
Recommended Silk PLA profile
| Hotend temperature | 215°C (tower 205–230°C) |
| Bed temperature | 55°C |
| Print speed | 56 mm/s |
| Retraction | 0.9 mm (direct drive) |
| Part cooling fan | 100% |
| Bed adhesion | Easy; print slower for the best sheen. |
| Nozzle | Brass 0.4 mm is fine |
| Difficulty | Beginner |
💡 Best uses for Silk PLA: decorative, vases, gifts.
FAQ
- What temperature should I print Silk PLA on the Elegoo Neptune 4?
- Start at 215°C for the hotend and 55°C for the bed, then run a temperature tower across 205–225°C to dial in your exact filament brand.
- What print speed works for Silk PLA on this printer?
- Around 56 mm/s is a safe starting point on the Elegoo Neptune 4. This printer can go faster once the profile is tuned, but start conservative for clean walls.
- What retraction should I use?
- Use about 0.9 mm of retraction (direct drive needs very little). If you see stringing with Silk PLA, raise retraction speed before distance and dry the filament.
- Do I need an enclosure for Silk PLA on the Elegoo Neptune 4?
- No, Silk PLA prints fine in the open on the Elegoo Neptune 4.