Home › Bambu Lab A1 mini › PLA
PLA settings for the Bambu Lab A1 mini
Great match
These are tuned starting settings for printing PLA on the Bambu Lab A1 mini. The Bambu Lab A1 mini has a direct-drive extruder and an all-metal hotend, so we set the hotend to 205°C and the bed to 60°C. PLA is the easiest filament to print and the best starting point for any printer.
205°C
Hotend
60°C
Bed
84 mm/s
Speed
100%
Part fan
Recommended PLA profile
| Hotend temperature | 205°C (tower 190–220°C) |
| Bed temperature | 60°C |
| Print speed | 84 mm/s |
| Retraction | 0.8 mm (direct drive) |
| Part cooling fan | 100% |
| Bed adhesion | Easy on most beds; glue stick optional. |
| Nozzle | Brass 0.4 mm is fine |
| Difficulty | Beginner |
💡 Best uses for PLA: prototypes, toys, figurines, decorative.
FAQ
- What temperature should I print PLA on the Bambu Lab A1 mini?
- Start at 205°C for the hotend and 60°C for the bed, then run a temperature tower across 190–215°C to dial in your exact filament brand.
- What print speed works for PLA on this printer?
- Around 84 mm/s is a safe starting point on the Bambu Lab A1 mini. This printer can go faster once the profile is tuned, but start conservative for clean walls.
- What retraction should I use?
- Use about 0.8 mm of retraction (direct drive needs very little). If you see stringing with PLA, raise retraction speed before distance and dry the filament.
- Do I need an enclosure for PLA on the Bambu Lab A1 mini?
- No, PLA prints fine in the open on the Bambu Lab A1 mini.