Home › Creality Ender 3 S1 Pro › PETG
PETG settings for the Creality Ender 3 S1 Pro
Great match
These are tuned starting settings for printing PETG on the Creality Ender 3 S1 Pro. The Creality Ender 3 S1 Pro has a direct-drive extruder and an all-metal hotend, so we set the hotend to 240°C and the bed to 80°C. PETG is strong and weather-resistant but strings easily, so tune retraction and keep the fan low.
240°C
Hotend
80°C
Bed
50 mm/s
Speed
50%
Part fan
Recommended PETG profile
| Hotend temperature | 240°C (tower 230–250°C) |
| Bed temperature | 80°C |
| Print speed | 50 mm/s |
| Retraction | 1.5 mm (direct drive) |
| Part cooling fan | 50% |
| Bed adhesion | Strong; use glue stick as a release agent, not for grip. |
| Nozzle | Brass 0.4 mm is fine |
| Difficulty | Intermediate |
💡 Best uses for PETG: mechanical parts, outdoor parts, bottles.
FAQ
- What temperature should I print PETG on the Creality Ender 3 S1 Pro?
- Start at 240°C for the hotend and 80°C for the bed, then run a temperature tower across 230–250°C to dial in your exact filament brand.
- What print speed works for PETG on this printer?
- Around 50 mm/s is a safe starting point on the Creality Ender 3 S1 Pro.
- What retraction should I use?
- Use about 1.5 mm of retraction (direct drive needs very little). If you see stringing with PETG, raise retraction speed before distance and dry the filament.
- Do I need an enclosure for PETG on the Creality Ender 3 S1 Pro?
- No, PETG prints fine in the open on the Creality Ender 3 S1 Pro.