Home › Bambu Lab P1S › Nylon (PA)
Nylon (PA) settings for the Bambu Lab P1S
Great match
These are tuned starting settings for printing Nylon (PA) on the Bambu Lab P1S. The Bambu Lab P1S has a direct-drive extruder and an all-metal hotend in an enclosed chamber, so we set the hotend to 260°C and the bed to 90°C. Nylon is extremely strong but soaks up moisture fast, so dry the spool before every print.
260°C
Hotend
90°C
Bed
56 mm/s
Speed
0%
Part fan
Recommended Nylon (PA) profile
| Hotend temperature | 260°C (tower 240–280°C) |
| Bed temperature | 90°C |
| Print speed | 56 mm/s |
| Retraction | 1.5 mm (direct drive) |
| Part cooling fan | 0% |
| Bed adhesion | Glue stick or PA-specific sheet; dry before printing. |
| Nozzle | Brass 0.4 mm is fine |
| Difficulty | Advanced |
💡 Best uses for Nylon (PA): gears, living hinges, tough parts.
FAQ
- What temperature should I print Nylon (PA) on the Bambu Lab P1S?
- Start at 260°C for the hotend and 90°C for the bed, then run a temperature tower across 240–270°C to dial in your exact filament brand.
- What print speed works for Nylon (PA) on this printer?
- Around 56 mm/s is a safe starting point on the Bambu Lab P1S. This printer can go faster once the profile is tuned, but start conservative for clean walls.
- What retraction should I use?
- Use about 1.5 mm of retraction (direct drive needs very little). If you see stringing with Nylon (PA), raise retraction speed before distance and dry the filament.
- Do I need an enclosure for Nylon (PA) on the Bambu Lab P1S?
- The Bambu Lab P1S is enclosed, which is exactly what Nylon (PA) needs for warp-free prints.